Automatic Zero Setting At Power-On; Zero Tracking; Setting Units Of Measure; Semi-Automatic Tare (Net/Gross) - LAUMAS TLU Installation And User Manual

Hide thumbs

Table Of Contents

Table of Contents

 (from 0 to max 20% of full scale; default: 0): If at switch-on the weight value is lower than

the value set in this parameter and does not exceed the  value, the weight is reset. To

disable this function, set 0.

 (from 1 to 5, default: ): When the weight value is stable and, after a second, it

deviates from zero by a figure in divisions smaller or equal to the figure in divisions set in this

parameter, the weight is set to zero. To disable this function, set .

Example: if the parameter  is set to 5 and   is set to 2, the weight will be automatically

set to zero for variations smaller than or equal to 10 ( x  ).

These are the available units of measure:

kilograms

:

:

grams

tons

:

THE SEMI-AUTOMATIC TARE OPERATION IS LOST UPON INSTRUMENT POWER-

OFF.

To perform a net operation (SEMI-AUTOMATIC TARE), close the NET/GROSS input or press the

TARE f key for less than 3 seconds. The instrument displays the net weight (just set to zero) and the

NET LED lights up. To display the gross weight again, keep the NET/GROSS input closed or press

TARE for 3 seconds.

This operation can be repeated many times by the operator to allow the loading of several products.

Example:

Put the box on the scale, the display shows the box weight; press TARE, the display shows the net

weight to zero; introduce the product in the box, the display shows the product weight. This

operation can be repeated several times.