Centrometal Cm Pelet-set Touch 14 Technical Manual page 5

SYMBOLS
1 9
2
3
4
5
6 7
Simboli:
1 - Boiler temperature
2 - Fuel level *
3 - Transporter is working
4 - Photocell
5 - Flame symbol
6 - Igniter is working
7 - Burner fan is working
8 - Burner fan rpm
9 - Burner working hours counter
10 - Burner working hours reset buttom
11 - Dynamic configuration view
(view depends on set configuration)
12 - Heating mode / Freeze guard /
Additional equipment view (cascade, wifi...)
13 - Outside temperature
14 - Boiler working stage
* - additional equipment
on screen only if additional equipment
is installed and enabled (fuel level sensor)
Pump (no demand to work)
Pump has demand to work (when there is demand to work, given by a customer, yellow rectangle appears
inside the pump symbol, but pump doesn't work if all the conditions are not fulfilled; i.e. too low temperature
in the boiler, otherwise it works). It rotates while working, it doesn't rotate while not working.
Technical manual - THE DIGITAL BOILER CONTROLLER Cm-Pelet set_Touch 14-90 kW
10
8
11
Boiler type display:
EKO-CK P +
Cm Pelet-set_Touch Cm Pelet-set_Touch
14-90 kw
12
14
EKO-CKB P +
Cm Pelet-set_Touch
EKO-CKB P +
+ recirculation
14-50
built in boiler
Symbols
13
14-50
5