Centrometal Cm Pelet-set Touch 14 Technical Manual page 24

Operation mode
SETTING PARAMETERS FOR EACH HEATING CIRCUIT
Regulation can control up to two mixing heating circuits. They must be enabled and set under "INSTALLATION" menu.
To make adjustment of each circuits go to the "OPERATION" menu then "STANDARD EQUIPMENT" menu.
Possible selection:
Factory: ON
Option: ON, OFF
By using this option you can enable/disable heating circuits.
Possible selection:
Factory: 1.0
Option: 0.1 - 4.0
By using this option you can set heating curve value.
Possible selection:
Factory: 1.0
Option: 0,1 - 5,0
By using this option you can set correction value.
24 Technical manual - THE DIGITAL BOILER CONTROLLER Cm-Pelet set_Touch 14-90 kW