Centrometal Cm Pelet-set Touch 14 Technical Manual page 23

5.6.3.1 - 5.6.4.2 1. CIRCUIT / 2. CIRCUIT
It's possible to view all enabled mixing heating circuits (set temperatures, measured temperatures, heating type,
working of the pumps etc...). To enter this view press
If there are more than 2 mixing heating circuits enabled you can switch view betwen them with
This schematic view is only possible to view, it is not possible to turn on / off / adjust individual elements.
General:
Specific elements can be individually adjusted and displayed for each heating circuit.
For example: Turn on / off the heating circuit, turn on / off the room corrector, select the type of heating circuit for each
circuit (radiator / floor), select the operation mode (daily / night).
1 - Mixing valve (1.circuit)
2 - The calculated flow temperature (1.circuit)
3 - Current measured flow temperature (1.circuit)
4 - Heating type on 1. circuit (radiators or floor heating)
5 - Room corrector „CSK" on 1. circuit (if turned off,
icon disappears)
Elements 1a - 8a have the same meaning as elements 1 to 8 (described above)
refer only to the 2nd heating circuit or or any heating mixing circuit involved
with respect to the number of circuits included.
Technical manual - THE DIGITAL BOILER CONTROLLER Cm-Pelet set_Touch 14-90 kW
/
2.
2a
3a
5a
4a
1a
5
1
2 3 4
6 - The desired temperature + deviation by room corrector
7 - Current measured room temperature (shown only
8 - Mode (1.circuit) (day / night)
9 - Outer temperature (outer sensor)
button and then
1.
9
6a
6
(1.circuit)
if the room corrector is turned on) in 1.circuit
Operation mode
.
buttons.
8a
7a
8
7
23