Operating Instructions - German pool WAC-407 User Manual

Operating Introduction
For mechanical control model
Operation
The mode knobs control fan speeds and cooling speeds. To set desired cooling temperature,
simply rotate the mode knob dial to the appropriate setting.
AUTO SWING Switch
When the Swing switch is turned to the "ON " positio n,
the vertical louvers automatically oscillate sweeping
the cold air for comfortable cooling.
The vertical louvers may be stopped at any position
when the Swing switch is turned "OF F".
Thermostat
The thermostat automatically controls the cooling
cycle ( compressor) of the air conditioner to main tain
room temperature. However, the fan motor will
continue to operate after the compressor (cooling
cycle) is completed.
Low Fan will circulate the air at a minimum speed
without cooling.
Med Fan will circulate the air at a medium speed
without cooling.
High Fan will circulate the air at a maximum speed
without cooling.
Low Cool provides cooling, automatically with
minimum air circulation. Recommended for night-
time use.
Med Cool provides cooling, automatically with
medium air circulation. Recommended for night-
time use.
High Cool provides cooling, automatically with
quick cooling or for extremely hot days. Once room
is cooled, reduce setting to Low Cool.
OFF will completely shut-off the unit.
NOTE
After setting the mode,allow 3 minutes before
switching to another mode.Fresh Air Ventilation is
usually kept in the closed position.Use only when
clearing smoke and/or odors from the room.
Based on real subject
!
W hen using FA N control, turn slowly allowing
unit to adjust.
When using T HE R MO STA T , be sure to allow
three minutes before changing temperature.
Adjusting too quickly may cause an overload
resulting in a blown fuse.
Close
Fresh Air Vent Lever
P.4
CAUTION
!
Pull
Open