Spectrum Industries 55496 Assembly Instructions

Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt. To
report information regarding missing parts or damage, to purchase parts or acces-
sories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
(1) 0140345
Keyboard Tray
(1pr) 050092
12" Slide set
1. Assemble slide brackets
1. Attach the 'L' brackets to each outer slide with screws (included
with slides). The brackets need to be attached "inboard" (facing
each other). Figure 1A.
• For Freedom XRS Lecterns, multiple height positions / mounting
holes are available with the brackets-use the same hole position
on all four brackets.
• For Pivot Premiere Lecterns, use the tallest position on all four
brackets.
2. Tighten the bracket screws securely.
3. Separate the inner from the outer slides using the black levers.
4. Raise the lectern up all the way and unplug the power cord.
(6) 0100167
8-32 x 1/2" PH
thread-cutting
screw
(8) 037542
#8 x 5/8" PHSM
Note: The 'L' brackets can be adjusted to provide varied keyboard
heights-the keyboard tray may protrude up to a maximum of 3.9" [10
cm] below the worksurface. If the lectern is used for ADA use, a higher
adjusted worksurface will be necessary to provide ADA leg clearance.
Pull-out Keyboard Tray
55496
'L' Bracket
Screw
(included with slides)
Phillips
Screwdriver
Inner slide
'L' Bracket
Outer slide
Figure 1
0191446 Page 1 of 3