Termination Card Details; Procedure To Terminate Wires To The Termination Card - VESDA LaserSCANNER VLS-200 Installation Manual

LaserSCANNER Installation Manual

6.11 Termination Card Details

Terminal A Terminal B
Pin 1 Pin 1
Pin 10
Figure 9 Termination Card Details for 7 Relays
Terminal A Terminal B
Pin 1 Pin 1
Pin 10
Pin 13
Figure 10 Termination Card Details for 12 Relays

6.12 Procedure to Terminate Wires to the Termination Card

Use the appropriate local wiring standards or use the following suggested procedure listed
below. Check Sections 6.13, 6.14 and 6.15 for specific information on terminal connections.
(a) Strip off 5 to 7mm (0.2 to 0.3in) of outer insulation from each wire.
(b) For multi-stranded wire only - Twist wire strands together.
14
Terminal C
Pin 1
Pin 11
Pin 12
VESDAnet
Socket
FOK LED
Connector
Terminal C
Terminal A
Pin 1
10 Power (-)
Pin 15
VESDAnet
Socket
FOK LED
Connector
Terminal A Terminal B
1 VESDAnet A+ 1 Isolate (NO)
2 VESDAnet A- 2 Isolate (C)
3 Shield 3 Isolate (NC)
4 VESDAnet B+ 4 Minor Fault (NO)
5 VESDAnet B- 5 Minor Fault (C)
6 Shield 6 Minor Fault (NC)
7 Power (+) 7 Urgent Fault (NO)
8 Power (-) 8 Urgent Fault (C)
9 Power (+) 9 Urgent Fault (NC)
10 Power (-) 10 Alert (NO)
11 Alert (C)
12 Alert (NC)
GPI = General Purpose Input
Terminal B
1 VESDAnet A+ 1 Urgent Fault (NO)
2 VESDAnet A- 2 Urgent Fault (C)
3 Shield 3 Urgent Fault (NC)
4 VESDAnet B+ 4 Relay 1 (NO)
5 VESDAnet B- 5 Relay 1 (C)
6 Shield 6 Relay 2 (NO)
7 Power (+) 7 Relay 2 (C)
8 Power (-) 8 Relay 4 (NO)
9 Power (+) 9 Relay 4 (C)
10 Relay 5 (NO)
11 Relay 5 (C)
12 Relay 7 (NO)
13 Relay 7 (C)
GPI = General Purpose Input
VESDA ®
Terminal C
1 Fire 2 (NC)
2 Fire 2 (C)
3 Fire 2 (NO)
4 Fire 1 (NC)
5 Fire 1 (C)
6 Fire 1 (NO)
7 Action (NC)
8 Action (C)
9 Action (NO)
10 GPI -
11 GPI +
Terminal C
1 Fire 1 (NO)
2 Fire 1 (C)
3 Fire 1 (NC)
4 Relay 12 (NO)
5 Relay 12 (C)
6 Relay 11 (NO)
7 Relay 11 (C)
8 Relay 10 (NO)
9 Relay 10 (C)
10 Relay 9 (NO)
11 Relay 9 (C)
12 Relay 8 (NO)
13 Relay 8 (C)
14 GPI -
15 GPI +
Version 1.3