Table of Contents
Advertisement
LaserSCANNER Installation Manual
6.7 Securing the Mounting Bracket
Warning:
Make sure that there are no electrical wires or plumbing behind the mounting
position before drilling. Ensure the mounting position is flat.
a) Remove the drilling template from the centre page of this manual.
b) Determine the orientation for the detector (Normal or Inverted Orientation). Place the drilling
template onto its mounting location in the correct orientation and drill out the appropriate
holes. Refer to the drilling template for orientation.
c) Use the appropriate fasteners to suit the mounting surface. Secure the bracket to the
surface.
6.8 Attaching the Detector onto the Bracket
(a) Determine the required orientation for the LaserSCANNER. Refer to Figure 3 for orientation.
(b) Place the three bridges located on the rear of the detector onto the three lances located on
the mounting bracket. Refer to Figure 8.
(c) Push the detector downwards until it locks onto the lances and engages the fitting dimples.
(d) Check the unit does not slip off its bracket.
(e) To remove, push the detector upwards and pull away from wall.
(f) To prevent unwanted removal of the detector, insert screw into the keyhole slot at location
shown on template and tighten screw. Drill out these holes before mounting the detector
onto its mounting bracket by using the supplied template to locate the screw hole position.
Insert at least one screw into one key hole slot located around the Termination Card area.
Figure 8 Mounting the Detector onto the Mounting Bracket
12
Fitting Dimples
VESDA
®
Rear of Detector
Bridge
Lance
Mounting Bracket
Version 1.3
Hide quick links:
Advertisement
Table of Contents
