Jet Ocean Pearls Service Manual page 48

Step # 13-L
After the marqee is aligned properly and the rear screws installed -
tighten the two front screws.
Step # 13-M
Locate the 12 volt wire harness and feed it through the hole in the
bottom left rear of the marquee.
Step # 13-N
After pulling the wires out of the back of the marquee, push the wires
into the access hole in the top of Section # 4.
Jennison Entertainment Technologies
INSTALLATION INSTRUCTIONS
Ocean Pearls Service Manual
Check Box When This Step is Complete
Check Box When This Step is Complete
Check Box When This Step is Complete
Page 48