Jet Ocean Pearls Service Manual page 22

Step # 3-L
Connect the 16 Pin Molex connector to the connector board. Be
careful as you push this connector into the board that no pins get
pushed out. If it does not fit properly and the pins do not line up
correctly the first time - DO NOT PUSH IT. Remove and re-attempt.
AS YOU MATE THE CONNECTION, BE SURE THAT NO
PINS GET PUSHED OUT.
Step # 3-M
Connect the 5 Pin Molex to the connector board. These wires control
the vertical and horizontal cascading LED lights on the front left and
right of the main cabinet and the lower horizontal LED lights along the
bottom of the control center and main cabinet.
AS YOU MATE THE CONNECTION, BE SURE THAT NO
PINS GET PUSHED OUT.
Step # 3-N
Connect the 6 Pin Molex connector to the connector board. The
Blue/Brown/Yellow-Green wires are high voltage wires for the bill
acceptor. Be careful when connecting these and ensure the pins do
not get pushed out if the connector does not seat correctly the first
time.
AS YOU MATE THE HIGH VOLTAGE CONNECTION, BE
SURE THAT NO PINS GET PUSHED OUT.
Jennison Entertainment Technologies
INSTALLATION INSTRUCTIONS
CAUTION
CAUTION
WARNING
Ocean Pearls Service Manual
Check Box When This Step is Complete
Check Box When This Step is Complete
Check Box When This Step is Complete
Page 22