Jet Ocean Pearls Service Manual page 27

Step # 4-G
DO NOT allow the unit to sit or stand on the four bolts (as shown in
the picture to the right). This can cause the bolts to bend and not
allow the nuts to thread properly durin installation.
Step # 4-H
As Section # 3 is on the ground, ensure that the 5 Pin LED connector
on the RIGHT side of the unit is properly plugged into the LED board
and seated properly. It will be difficult to reach this connection after
the unit is assembled.
Step # 4-I
As Section # 3 is on the ground, ensure that the 5 Pin LED connector
on the LEFT side of the unit is properly plugged into the LED board and
seated properly. It will be difficult to reach this connection after the
unit is assembled.
Jennison Entertainment Technologies
INSTALLATION INSTRUCTIONS
Ocean Pearls Service Manual
Check Box When This Step is Complete
Check Box When This Step is Complete
Check Box When This Step is Complete
Page 27