Open-Me-First
4.4 Jaguar Video Frame Connectors Continued:
Control (PRC) Connectors Continued:
The pinout of the 9-Pin Control Connector is as follows:
PIN NO.
1
2
3
4
5
6
7
8
9
The pinout of 5-Pin Control Connector is as follows:
PIN NO.
1
2
3
4
5
For PRC communications, the user should use a direct pin-for-pin cable for
interfacing between the control connectors and the peripheral equipment.
DO NOT use a "NULL MODEM" cable.
Serial (CPU Link) Connectors (SERIAL 1 and SERIAL 2)
The CPU Link connectors allow serial communications between the inter-
nally installed 3300 Controllers and up to two external computers. The 3300
Controller supports asynchronous, bidirectional communications, at 9600
baud. The protocol used in communication via these ports is a proprietary
protocol developed by PESA for switcher control. Be sure to use a "null
modem" cable for all serial (CPU link) connections. The pinout for CPU link
connectors is as follows:
page 4.10
System Connections
Section 4
DESCRIPTION
GROUND
RX+ DATA
TX- DATA
GROUND
SPARE
GROUND
RX- DATA
TX+ DATA
GROUND
DESCRIPTION
TX+ DATA
TX- DATA
GROUND
RX+ DATA
RX- DATA
P/N 81905903820
07/96