Table of Contents
Advertisement
Open-Me-First
3.1 Introduction
IF SPECIFIED WHEN ORDERED, THE COUGAR OR JAGUAR SWITCHING SYSTEM
WILL BE CONFIGURED FOR THE INTENDED MATRIX SIZE AT THE FACTORY PRIOR
TO SHIPMENT. PLEASE CONTACT THE PESA CUSTOMER SERVICE DEPARTMENT,
LISTED IN THE FRONT OF THIS MANUAL, BEFORE CHANGING ANY SWITCH SET-
TINGS WITHIN THE SYSTEM OR RE-CONFIGURING THE SYSTEM.
The configuration of the Cougar and Jaguar Switching Systems consists
of setting level, input, and output code for each video frame. The configu-
ration also consists of setting level, input, and output codes for each audio
stereo matrix (Matrix A and Matrix B form a stereo pair). Additionally, level,
input, and output codes must be set for each output monitor card where
applicable (Jaguar Routing Switchers only).
The level, input, and output selections identify each video frame, audio
matrix, or monitor card to the system controller. The desired level, input,
and output codes are selected by setting binary-coded DIP switches to the
correct positions. For switch position to binary code conversion refer to
Table 3-1.
Table 3-1 Switch Position to Binary Code Conversion
SWITCH POSITION TO BINARY CODE CONVERSION
PHYSICAL SWITCH POSITION
07/96
P/N 81905903820
System Configuration
NOTE
1
2
3
4
5
6
7
8
Section 3
BINARY CODE
1
2
4
8
16
32
64
128
page 3.1
Advertisement
Table of Contents
