Table of Contents
Advertisement
Fuse Replacement
To replace the PS13O Power Supply line fuses take the following steps:
1. Disconnect the AC power cord from the power supply being
serviced.
2. Remove or open the front door of the equipment item containing the
PS130 Power Supply needing serviced.
3. Remove the power supply from the equipment item. Refer to the
Power Supply Removal Section of this addendum for power supply
removal instructions.
4. Carefully pull the AC line fuse holder open. The fuse holder is located
adjacent to the PS130 Power Supply AC line input connector.
5. Replace the fuses with fuses of equal current and voltage rating.
6. Carefully slide the AC line fuse holder closed.
7. Install the power supply back into the equipment chassis. Refer to the
Power Supply Installation Section of this addendum for complete
power supply installation instructions.
5. Reconnect the associated AC power cord.
page 6
ADDENDUM
*CAUTION*
DOUBLE-POLE/NEUTRAL FUSING
Internal PS130 Power Supply Addendum
06/97
Advertisement
Table of Contents
