Table of Contents
Advertisement
Chapter 1 – Introduction
General
This manual provides instructions for the installation, operation, and maintenance of the PESA Tiger video
routing switcher.
Safety Warnings
Safety warnings, and other important information, are emphasized in three ways:
Product Description
Each Tiger video routing switcher can switch 144 inputs to 144 outputs and may contain a mix of both analog
and digital components. Multiple chassis (both audio and video) may be connected into a system operated by a
single controller.
Inputs for two different vertical sync inputs allow the switching of two different signal formats in the same
chassis. Composite sync, black burst, and standard analog signals in either NTSC or PAL formats may be used.
All Tiger video routing switchers offer alarm support, switch confirmation, block checking, and power-out-of-
range indicators.
Optional equipment includes:
1. An analog or digital output monitor control board. The output monitor control board controls an
internal, 144x1 switching matrix which can be used to monitor any output in the frame downstream of
the last amplifier and switch circuit. In a multi-frame system, one output monitor control board must be
installed in each frame containing signals to be monitored.
2. A system controller with full software diagnostic capability.
Chapter 1 – Introduction
Tiger Video Routing Switcher
WARNING
Warning statements identify conditions or practices that could
result in personal injury or loss of life.
CAUTION
Caution statements identify conditions or practices that could
result in damage to equipment.
Notes add emphasis to information that is important for the
correct installation, operation, or maintenance of the
equipment.
NOTE
1
Advertisement
Table of Contents
