Advertisement
Step 11
Step
Fasten two HINGES (HH) and HINGE SPACERS (JJ) to the
å
DOOR (K). Use four SILVER 5/8" FLAT HEAD SCREWS (ZZ).
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (K) to the RIGHT END (A) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Peel the FELT DISCS from the FELT DISC CARD (SS).
å
Stick a FELT DISC on the DOOR where it comes in
contact with the UPRIGHT (C).
Insert a HANDLE (KK) into two HANDLE MOUNTS (LL)
å
and fasten them to the DOOR (K). Use two SILVER 5/8"
MACHINE SCREWS (YY).
See the next step for DOOR adjustments..
å
Page 16
SILVER 5/8" FLAT HEAD SCREW
(4 used for the HINGES)
C
Stop
Mounting
screw
Hinge
K
ZZ
KK
LL
K
A
SS
SILVER 5/8" MACHINE SCREW
(2 used for the PULL)
HH
JJ
YY
Advertisement
