Table of Contents
Advertisement
Power failure
As a precaution, the switch should be unplugged in case of power failure. When power is resumed,
plug the switch back in.
Getting Started
This chapter introduces the management interface of Web Managed Ethernet switch.
Management Option
The Web Managed Ethernet switch can be managed through any port on the device by using the
Web-based management.
Each switch must be assigned its own IP address, which is used for communication with Web-
Based Management or a SNMP network manager. The PC should have an IP address in the same
range as the switch.
Please refer to the following installation instructions for the Web-based Management.
Using Web-based Management
After a successful physical installation, you can configure the Switch, monitor the network status,
and display statistics using a web browser.
Supported Web Browsers
The embedded Web-based Management currently supports the following web browsers:
Internet Explorer 6 or higher version
Netscape 8 or higher version
Mozilla
Firefox 1.5/2.0 or higher version
Connecting to the Switch
You will need the following equipment to begin the web configuration of your device:
1. A PC with a RJ-45 Ethernet connection
2. A standard Ethernet cable
Connect the Ethernet cable to any of the ports on the front panel of the switch and to the
Ethernet port on the PC.
Advertisement
Table of Contents
