Table of Contents
Advertisement
opening, as seen in the figure below.
Step 3: Insert the ground screw into the ground-screw opening.
Step 4: Using a screwdriver, tighten the ground screw to secure the ground cable to the
switch.
Step 5: Attach the terminal lug ring at the other end of the grounding cable to an
appropriate grounding stud or bolt on rack where the switch is installed.
Step 6: Verify if the connections at the ground connector on the switch and the rack are
securely attached.
3.4 Plugging in the AC Power Cord
Users may now connect the AC power cord into the rear of the switch and to an electrical outlet
(preferably one that is grounded and surge protected).
Power Failure
As a precaution, the switch should be unplugged in case of power failure. When power is resumed,
plug the switch back in.
3.5 Connecting Ethernet Interface
Use switch's UTP to connect to other Ethernet terminals. Refer to the following chart:
DG-FS1510HPE User Guide
8
Advertisement
Table of Contents
