Table of Contents
Advertisement
Initial fi lling - fl ooding the pump
WARNING! Do not put the water station into operation unless the pump is fl ooded to prevent the motor
seizure resulting from melting its parts by overhearing - dry operation.
WARNING! The pump should be fl ooded before being put into operation. Do not put the water station into
operation unless it's fi ĺled with water!
Before starting the pump, fi ll it completely with clean water through the supply/de-aeration orifi ce (3).
Unscrew the fi lling tube orifi ce plug (2) and fi ll the pump with water. You can also fi ll the pump directly
through the output hole.
Then screw the fi lling tube orifi ce plug (2) back.
The initial pump fi lling procedure should be repeated whenever the equipment has been left unused for
a prolonged period of time or whenever air gets inside the system.
NOTE: Make sure that the pump is fully fl ooded along the entire length of the suction hose.
5. PUTTING INTO OPERATION
To turn on
1. Connect the suction and output hose properly.
2. Fill the pump housing with water through the fi lling hole after the plug has been unscrewed.
3. Open the output pipes.
4. Connect the mains cord and set the switch in the "ON" position.
5. The suction procedure will start automatically.
To turn off
Set the switch to the "OFF" position.
ATTENTION! The initial pump fl ooding procedure should be repeated whenever the equipment has been
left unused for a prolonged period of time or whenever air gets inside the system.
It is required that the aggregate operation should be checked and the problems should be fi xed in time to prolong
the aggregate lifetime and increase its effi ciency.
GARDEN WATER-STATION
Technical specifi cations | Disposal
9
EN
USER'S MANUAL
Advertisement
Table of Contents
