Grounding; Laser Product - Avaya G700 Welcome Manual

!
WARNING:
The Avaya™G700 Media Gateway must not be operated with any slots open. Empty
slots should be covered with the supplied blank plates.

Grounding

!
CAUTION:
System grounding must comply with the general rules for grounding provided in Article 250
of the National Electrical Code (NEC), National Fire Protection Agency (NFPA) 70, or the
applicable electrical code in the country of installation.
!
WARNING:
If the installation location is greater than 50 feet (15 m) from an approved ground, do
not install the Avaya™G700 Media Gateway until a licensed electrician is present to
install a Supplementary Ground Conductor.
!
WARNING:
Failure to install both grounds will void the Product Safety certifications (UL and the
CE Mark) on the product and create a hazard that could result in death or severe
personal injury.

LASER Product

The equipment described in the documentation for this product may contain Class 1 LASER
Device(s). The LASER devices operate within the following parameters:
• Power output –9.5 dBm to -4 dBm
• Wavelength 1285 nm to 1343 nm
CLASS 1 LASER PRODUCT EN 60825-1:1994 + A11, EN60825-2:194, EN60950:1992 + A1 + A2
+ A3.
Laser components used in the G700 Media Gateway are Class 1 Laser Products that comply with
21CFR 1040.10 and CFR 1040.11.
Use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure. Contact your Avaya representative for more laser product
information.
Luokan 1 Laserlatte
Klass 1 Laser Apparat
Welcome to S8300/S8700 and G700
555-234-200 — Issue 2 — October 2002
About this Book: Safety Notices
9