Device Manager Login Procedure - Avaya G700 Welcome Manual

6 . Enter your login confirmation information as prompted:
- Password prompt. Type your password in the Password field, and click Login or press Enter
again.
- ASG challenge. If your login is Access Security Gateway (ASG) protected, you will see a
challenge screen. Enter the correct response and click Login or press Enter.
7 . The server will match your login information against its authentication tables. If the information
you entered is recognized as a valid login, the screen displays a two-frame window, with the main
menu in the left panel and a usage-agreement notice in the right window.
- If the main menu in the left panel has only about 10 links, you have accessed the server from
a login ID that has restricted permissions. You can adjust the login service levels using the
Login Administration screen in Avaya™ Site Administration or SAT.
- If the server cannot recognize your user name or password, you receive an authentication
failure message. Return to step 5. If you fail to enter the user name and login confirmation
correctly 4 times within a few minutes, the Login screen will block further attempts to log in
for a while.
8 . When you successfully log in to the server, check the top of the left panel.
- The Avaya Media Server you are logged into is identified by name and server number.
- The S8300 Media Server number is always 1.

Device Manager login procedure

To access the Device Manager, you must:
1 . Establish a valid physical connection to either the Layer 2 Switching Processor or G700 Media
Gateway processor. See
2 . Open a compatible Internet browser on your computer. Currently this includes Internet Explorer
5.0 (or higher) and Netscape Navigator 4.7 and 6.2. The Java Plug-in 1.2.2 or 1.3.1 is required.
3 . In the Address (or Location) field of your browser, type the IP address or name of the Layer 2
Switching Processor and press Enter.
- If you are accessing the Device Manager over a corporate LAN, and if the network includes a
domain name service (DNS) server that has been administered with this IP device's name,
you can type the processor's name into the address field instead of the IP address. For
example, http://P330-stack1.mycompany.com
- The Device Manager is not available through the S8300 Media Server. You must be
connected to either the Layer 2 Switching Processor or G700 Media Gateway processor
through the corporate LAN interface (either by a directly connected cable or remote access).
4 . A GUI rendering of the stack devices appears. Proceed with Media Gateway or stack device
administration.
Welcome to S8300/S8700 and G700
555-234-200 — Issue 2 — October 2002
Access Procedures: Specific Access Procedures
Connecting to an Ethernet interface for details.
31