Connecting Oscilloscope Probes - Keysight Infiniium S Series User Manual

Connecting Oscilloscope Probes

1
2
3
.
Probe Comp
DIGITAL D15-D0
Digital channels input
Figure 3 S-Series oscilloscope probe connectors
Do not exceed the maximum input voltage rating.
CAUTION
The maximum input voltage for the 50 Ω input impedance setting is ±5 V.
The maximum input voltage for the 1 MΩ input impedance setting is 30 Vrms or
±40 Vmax (DC+Vpeak)
Probing technology allows for testing of higher voltages; the included N2873A 10:1
probe supports 300 Vrms or ±400 Vmax (DC+Vpeak). No transient overvoltage
allowed.
When measuring voltages over 30 V, use a 10:1 probe.
CAUTION
The Keysight Infiniium S-Series oscilloscopes are not rated for Measurement
Category II, III, or IV.
Keysight Infiniium S-Series Oscilloscopes User's Guide
Attach the probe connector to the desired oscilloscope channel or trigger input
using the probe instructions.
Connect the probe to the circuit of interest using the browser or other probing
accessories.
Disconnect the probe.
1
All Inputs
2 3
~
1M ~ 14pF
1M Ω ±40V MAX
+
50 5V MAX
4 analog input channels where
probes are connected
Setting Up the Oscilloscope
3
Push Push
for Vernier to Zero
4
4
1
17