Using Markers; Controlling Digital Channels - Keysight Infiniium S Series User Manual

Using markers

Markers make it easier to make precise measurements because the marker
measurement readouts show exact voltage and time positions for the markers. The
measurements are based on actual waveform data from the acquisition system,
not on approximations based on the display position, so you can be sure the values
are highly accurate.
Using the marker and measurement controls, you can control multiple sets of
markers within the oscilloscope grid.
Both time and voltage differences between the markers are updated continuously
on the screen. By default, the markers track the source waveform. Voltage
measurements from the markers are the value of the waveform at the time set with
the marker arrow keys.
• To add a marker, press the [Markers] key or choose Measure/Mark > Add Markers...
• To select one of the markers, push the Position knob. Turn the knob to move
• Marker 1 has a solid line pattern on the waveform display. It is associated with
• You can drag a marker to quickly move to the position you want on the
• You can use the front panel Position knob for fine adjustment, or use the Add

Controlling digital channels

If your oscilloscope is an MSO model, choose Setup > Digital Channels... to open the
Digital dialog box so you can set up controls for the digital channels.
To turn the digital channels on, click the Add Waveforms button
check box next to the
Keysight Infiniium S-Series Oscilloscopes User's Guide
or click the Markers button
drawing in the Description area of the dialog box.
the marker. Push the knob again to select the next marker.
the first available source on the display.
waveform.
Markers dialog box to set the marker position precisely.
, then select the sources and mode. Notice the
, or press [Digital].
2
Using the Oscilloscope
and select the
43