Using The Setup And Display Controls; Using Auto Scale And Default Setup; Using The Touch Screen; Clearing The Waveform Display - Keysight Infiniium S Series User Manual

Using the Setup and Display Controls

With the setup and display controls you can quickly get a stable waveform display,
enable or disable the touch screen, clear the display, and set the oscilloscope to a
known starting condition.
Figure 11 Setup and display control keys

Using Auto Scale and Default Setup

To automatically configure the oscilloscope to best display the current input
signal(s), press [Auto Scale] or choose Control > Autoscale.
To reset the oscilloscope to its default setup, press [Default Setup]. You can use the
Undo button
Save the Current Oscilloscope Configuration
N OTE
Before using the default setup, you may want to save the current oscilloscope configuration
for later use. See the online help (described in chapter 3) for instructions on saving setups,
and for information on the exact configuration that is set when you use the default setup.

Using the Touch Screen

1
2
Now you can use gestures to flick items horizontally, drag a waveform vertically,
drag horizontally to change the horizontal delay, pinch horizontally to adjust
time/div and delay settings, pinch vertically to adjust a waveform's V/div and
offset settings, or tap to select waveforms and other selections on the display.

Clearing the Waveform Display

When you press [Clear Display] or click
waveform data from the display in preparation for another acquisition. If the
oscilloscope is in Run mode and is receiving triggers, it will update the display as it
collects new waveform data.
Clearing the waveform display also resets averaging, infinite persistence, color
grade persistence, histograms, and the mask testing database.
Keysight Infiniium S-Series Oscilloscopes User's Guide
Auto Clear
Touch
Scale Display
to undo a default setup.
To enable the touch screen so it responds to multi-touch gestures, similar to
those used on tablets and smart phones, press [Touch] or choose Utilities > User
Preferences... and select the Enable Touch Screen check box.
Touch the drag waveform icon
Default
Setup
to highlight it.
, the oscilloscope clears acquired
2
Using the Oscilloscope
33