System Configuration; Insert Evaluation Chip - Fujitsu MB904 Series Application Note

2.2 System Configuration

To work with the MB2147-05 some system configurations must be done as:
-
-
-
-
Note: To avoid any damages to the system, all configurations must be done when the
emulation and target system is switched off from any power supply.

2.2.1 Insert Evaluation Chip

The following pictures show the evaluation chip and the corresponding configuration
switches and jumpers.
To insert the evaluation chip lift the lever beside the socket and insert the chip in the right
position. Pin 1 of the evaluation chip is marked with a golden rectangle. Beside the socket a
black arrow on the metal case of the emulator is marking Pin 1 position of the socket. The
following picture shows the right position of EVA-Chip. After insertion of the chip, the lever
can be removed to its horizontal position, fastening the EVA-Chip in the socket.
Figure2.3.1.1 Configuration Area for the Evaluation Chip
MCU-AN-390077-E-V11
Chapter 2 Hardware Installation
Insertion of Evaluation chip (EVA-Chip)
define clock supply for main clock
define clock supply for sub-clock
connection of C-Pin
- 10 - © Fujitsu Microelectronics Europe GmbH