Set-Up Debug Configuration; Configure Debug Set-Up - Fujitsu MB904 Series Application Note

4 Set-up Debug Configuration

4.1 Configure Debug Set-up

When the Softune Workbench and the communication drivers have been installed the
debugger set-up file must be configured first before starting the debugger. For this purpose
the following steps must be performed.
-
-
-
© Fujitsu Microelectronics Europe GmbH
Change odd page title here
Chapter 4 Set-up Debug Configuration
Open your Softune Workbench project
Workspace> menu.
The upcoming dialog allows you to specify the project / workspace file.
Select the corresponding project file. Either select the .prj or .wsp file.
If the project has been developed with a previous Softune Workbench
version, the file type will be converted: select file type .prj for older
Softune workbench projects or .wsp for projects developed with newer
Softune Workbench versions supporting workspaces.
If a .prj file is selected, the project file will be converted automatically
by Softune Workbench into a .wsp file.
- 15 -
using the <File>, <Open
MCU-AN-390077-E-V11