And Finally - Fronius Robacta Reamer V Twin Manual

3
4
5
6

And finally...

Manually tilt the cleaning motor to the side to be adjusted and move to the highest po-
sition
Adjust the respective banking screw so that the cleaning cutter cannot collide with a
contact tip or a gas nozzle
Return the cleaning motor to the lowest position
Secure the banking screw using the nut (2) or (3) undone previously
(1) (1)
(1) (1)
Undo nut (2) or (3) depending on the
1
stop angle to be adjusted
Depending on the stop angle to be ad-
2
(4)
justed, undo banking screw (4) or (5)
until the cleaning motor can be moved
(2)
to the highest position where it is not in
contact with the welding torch parts
(3)
(5)
Manually move the cleaning motor to
7
the highest position
Manually tilt the cleaning motor to the
8
0,5-1mm
0.02-0.004in
left and right
- the cleaning cutter must not colli-
de with the contact tips or gas
nozzle
If the cleaning cutter touches welding
9
torch components, adjust the stop ang-
le again
2-3mm
0.08-0.12in
Screw on the cleaning device housing
1
cover using the four original screws
and washers (1)
65