Screwing The Cleaning Device To The Underlying Surface; Screwing The Cleaning Device And Installation Stand To The Underlying Surface - Fronius Robacta Reamer V Twin Manual

Screwing the cleaning device to the underlying sur-
face
Screwing the
cleaning device
and installation
Different fixings may be required to set up the installation stand depending on the
stand to the un-
type of underlying surface (foundation).
derlying surface
Fixings are therefore not included in the scope of supply of the installation stand. The in-
staller is responsible for selecting the right type of fixing.
1
2
Screwing the
cleaning device
to the underlying
Different fixings may be required to set up the device depending on the type of un-
surface
derlying surface (foundation).
The fixings supplied may only be used on an underlying surface (foundation) thickness of
5 mm (0.197 in.) or less.
Do not use the fixings supplied to set up the device on an underlying surface (foundation)
thickness greater than 5 mm (0.197 in.). In this situation the installer is responsible for se-
lecting the right type of fixing.
1
34
NOTE!
Place the optionally available installation stand on a level, firm and vibration-free sur-
face (foundation)
- Position the installation stand in such a way that the distance the robot has to trav-
el to the cleaning device on the installation stand is as short as possible
Screw the installation stand to the underlying surface (foundation) using the appropri-
ate fixings
4 x
NOTE!
Place the cleaning device on a level, firm and vibration-free surface (foundation)
- Position the cleaning device in such a way that the distance the robot has to travel
to the cleaning position is as short as possible
Position the cleaning device on the in-
3
stallation stand
Position the spatter tray on the clea-
4
ning device as shown
Securely screw the cleaning device
5
and spatter tray to the installation
stand as shown. Use the fixings sup-
plied with the cleaning device