Safety Rules; General; Proper Use; Environmental Conditions - Fronius Robacta Reamer V Twin Manual

Safety rules

General

The device is manufactured using state-of-the-art technology and according to recognised
safety standards. If used incorrectly or misused, however, it can cause:
-
-
-
All persons involved in commissioning, operating, maintaining and servicing the device
must:
-
-
-
The operating instructions must always be at hand wherever the device is being used. In
addition to the operating instructions, attention must also be paid to any generally applica-
ble and local regulations regarding accident prevention and environmental protection.
All safety and danger notices on the device
-
-
-
-
For the location of the safety and danger notices on the device, refer to the section headed
"General" in the operating instructions for the device.
Before commissioning the device, rectify any faults that could compromise safety.
This is for your personal safety!

Proper use

The device is to be used exclusively for its intended purpose.
The device is intended solely for the mechanical cleaning of Fronius robot welding torches
in automatic mode.
Any use above and beyond this purpose is deemed improper. The manufacturer shall not
be held liable for any damage arising from such usage.
Proper use includes:
-
-
-
The device is designed for use in industry and the workshop. The manufacturer accepts
no responsibility for any damage caused through use in a domestic setting.
The manufacturer likewise accepts no liability for inadequate or incorrect results.
Environmental Operation or storage of the device outside the stipulated area will be deemed as not in ac-
conditions cordance with the intended purpose. The manufacturer shall not be held liable for any dam-
age arising from such usage.
Ambient temperature range:
-
-
injury or death to the operator or a third party,
damage to the device and other material assets belonging to the operating company,
inefficient operation of the device.
be suitably qualified,
have sufficient knowledge of automated welding, and
read and carefully follow these operating instructions as well as the operating instruc-
tions for all system components.
must be in a legible state,
must not be damaged,
must not be removed,
must not be covered, pasted or painted over.
carefully reading these operating instructions
following all the instructions and safety rules in these operating instructions
performing all stipulated inspection and maintenance work
during operation: 0 °C to + 40 °C (32 °F to 104 °F)
during transport and storage: -25 °C to +55 °C (-13 °F to 131 °F)
9