Table of Contents
Advertisement
Relative humidity:
-
-
Keep ambient air free from dust, acids, corrosive gases and substances, etc.
Can be used at altitudes of up to 2000 m (6500 ft)
Obligations of the
The operator must only allow persons to work with the device who:
operator
-
-
-
Checks must be carried out at regular intervals to ensure that operators are working in a
safety-conscious manner.
Obligations of
Before using the device, all persons instructed to do so undertake:
personnel
-
-
Before leaving the workplace, ensure that people or property cannot come to any harm in
your absence.
Specific hazards
Stay out of the working area of the robot.
The device must be incorporated into a higher-level safety system within a secured area.
If this area has to be accessed when setup and maintenance work is carried out, make sure
that
-
-
If untrained operators have access to the device, its compressed air supply must be dis-
connected for the duration of work in accordance with "Performance Level d" of the ISO
13849-1 standard.
In addition to these Operating Instructions, the safety rules issued by the robot manufac-
turer must also be observed.
Keep your body, especially your hands, face, hair, clothing and all tools away from moving
parts, such as:
-
-
-
-
Do not touch cleaning cutters immediately after use - risk of burns. Observe the special
safety rules in the Operating Instructions for handling cleaning cutters.
Protect hands, face and eyes against flying parts (shavings, etc.) and compressed air/part-
ing agent mixture escaping from the parting-agent injection nozzle.
Covers may only be opened/removed for the duration of any maintenance, installation or
repair work.
10
up to 50 % at 40 °C (104 °F)
up to 90 % at 20 °C (68 °F)
are familiar with the fundamental instructions regarding safety at work and accident
prevention and have been instructed in how to use the device
have read and understood these operating instructions, especially the section "safety
rules", and have confirmed as much with their signatures
are trained to produce the required results.
to observe the basic instructions regarding safety at work and accident prevention
to read these operating instructions, especially the "Safety rules" section and sign to
confirm that they have understood them and will follow them.
the entire system is switched off for the duration of the work in this area
and that it is prevented from starting up accidentally, e.g. as the result of a control fault.
rotating cleaning cutter
upwards/downwards travelling cleaning motor
extending/retracting gas nozzle clamping device
wire cutter
Advertisement
Table of Contents
Troubleshooting
