Scope of supply
not shown:
(5)
(6)
(7)
Available options
The following options are available for the cleaning device:
-
-
-
How the wire cut-
The wire cutter opens and closes when there is an active signal from the robot control.
ter works/Maxi-
mum wire
Two wire electrodes with a diameter of up to 1.6 mm (0.063 in.) can be cut at the same
diameter
time by the cleaning device wire cutter.
Warning notices
The Robacta Reamer V Twin is fitted with warning notices and a rating plate. The warning
on the device
notices and rating plate must not be removed or painted over.
18
Standard I/O connecting plug (X1) without cable
Operating instructions
Fixings for assembling the cleaning device:
-
4 screws
-
4 washers
-
4 lock washers
-
4 nuts
Installation stand
Cleaning cutter adjustment aid
Level sensor
NOTE!
(1)
The "Robacta Reamer" parting agent
(item number 42,0411,8042) and the cle-
aning cutter are not part of the scope of
supply.
(1)
Robacta Reamer V Twin cleaning
device with wire cutter
(2)
(2)
Spatter tray
(3)
(3)
Tightening key for cleaning motor
(4)
Compressed air relief valve
(4)