Table of Contents
Advertisement
8: Regulations
This device complies with Part 15 of the FCC Rules
Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received, including in-
terference that may cause undesired operation. This equipment has
been tested and found to comply with the limits for a Class B dig-
ital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Changes and modifications not expressly approved by the manufac-
turer or registrant of this equipment can void your authority to op-
erate this equipment under Federal Communications Commission's
rules.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator and your body.
Industry Canada (IC) Compliance Notice
This device complies with Industry Canada license-exempt RSSs. Op-
eration is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interfer-
ence, including interference that may cause undesired operation of
the device.
Cet appareil est conforme aux normes d'exemption de licence RSS
d'Industry Canada. Son fonctionnement est soumis aux deux condi-
tions suivantes : (1) cet appareil ne doit pas causer d'interférence et
(2) cet appareil doit accepter toute interférence, notamment les
in-terférences qui peuvent affecter son fonctionnement.
15
regulatIons
Advertisement
Table of Contents
