Tormax Automatic Smart Drive 1101 Manual page 9

Operating Mode OPEN
Door Lock
Feedback Door State
Power Supply 24 VDC
Reversing Motion
Time Control
Step Control
Internal Protective Device
Power Failure
The door opens and stops in open position. It opens according to the settings of "Teach-
In General".
Unlocks on each opening command. On completion of the opening time delay, the door
starts opening. When the door has moved somewhat in opening direction, the door lock
drops off again. The door lock is activated only in proximity of the "door closed" position.
The feedback "door closed" (or "door open" if reconfigured) between 11–12 is only valid
as long as mains supply is available. This message is established as soon as the
processor considers the driving function as complete. Connection for 24 VDC relay or
signal light. Transistor output short circuit proof in relation to internal supply voltage
24 VDC / 0.75 A.
If a second opening width has been configured (Teach-In SS) the feedback "door open"
is as follows:
Triggering of opening
Activator
Key-switch
Push-and-Go
Manual operation
Using this function automatically changes the settings of Feedback Door State to "door
opening or door open". The other feed back types can be chosen, but have no effect
whatsoever. (See: Safety device Bodyguard).
The control system Smart Drive 1101 provides a power supply of 24 VDC for sensors,
door lock and signalling. The power supply may be continuously loaded with maximally
0.75 A. With loads >0.75 A, the point LED on the display goes out. On overload, the unit
switches itself off automatically. In this condition, manual operation of the door is possible
with controlled spring closing action.
If the door hits a firm obstacle during opening, the motor driven opening procedure is
terminated immediately. If the door hits a firm obstacle during closing, the weak spring
closing force remains in existence. The next opening command opens the door again as
usual.
The door opens when an impulse is received, remains in the valid open position during
the valid hold-open time, and closes thereafter again.
The door opens when an impulse is received (from the key switch or an activator) and
remains in the open position. The door closes immediately after the next impulse. The
motional sequence depends on the settings of the respective "Teach-In".
The motor is switched off immediately when the door is blocked.
Motor and transformer contain thermal relays that interrupt the current supply to the
control system at 110 °C. The system operates as during a power failure until the
temperature drops to 85 °C.
The door can be manually opened if the door lock can be unlocked with the door handle.
The door closes through spring force. The motor, which is controlled short-circuited,
controls the closing action with constant braking power. After return of power, the system
is immediately ready for use again.
Installation On Site SWINGDOOR Smart Drive 1101 T-1132 e
Feedback defined by
Teach-In General
Teach-In key-switch
Teach-In General
the smaller of both opening widths
9