Minolta EP5000 General, Mechanical/Electrical page 235

Interleaf EP5000/EP4000 SWITCHES ON PWBs, TECH. REP. SETTINGS
97.04.01
1156SBS040403A
Touch Panel
Display
Auto Panel Reset Specify the default exposure mode selected automatically when power is turned
ON or the Panel Reset key pressed.
Energy Saver Mode Set the time it takes the copier to enter the Energy Saver mode after a copy cycle
has been completed or the last key operated. Use the 10-Key Pad to set the time
(1 to 240 min.).
NOTE: The OFF setting is available for European areas only.
Drum Dehumidifier Select whether to allow the copier to enter the Drum Dehumidifier mode automat-
ically after it has been turned ON, or not.
Counter Removal Select whether to reset the panel or not when the Plug-In Counter is pulled out
of the copier, a magnetic card is pulled out of the Data Controller, or the Access
Mode key is pressed.
1156SBS040404A
Touch Panel
Display
Intelligent Sort
Select whether to turn "ON" or "OFF" the function that automatically switches be-
tween Sort and Non-Sort according to the number of originals loaded in the docu-
ment feeder.
NOTE: This function is enabled when "Mixed Orig. Detection" is
Confirmation Beep Select whether to turn "ON" or "OFF" the beep that sounds each time a key on
the control panel is pressed or that on the Touch Panel is touched.
Original Thickness Select whether to allow ("Thin") the user to make copies from thin originals in
addition to the standard ones or not ("Standard") using the document feeder.
The orginal is pressed against the
Original Width Scale when stopped.
Smaller Originals Select whether to enable ("ON") a copy cycle or not ("OFF") when it is initiated
by pressing the Start key with an original of the smallest detectable size (metric
areas: A5 or smaller; inch areas: Letter or smaller) placed on the Original Glass.
The copy cycle is run using the paper
loaded in the default paper source.
NOTE: The default setting is OFF for the metric areas and ON for the inch
[3/6]
Setting (The default is
30 sec.
1 min.
3 min. 5 min.
1 to 240 (15 min.)
ON
ON
[4/6]
Setting (The default is
ON
turned "OFF" and the copier is in the Auto Paper or Auto
Size mode.
ON
Standard
The original is not pressed against the
Original Width Scale when stopped.
ON
areas.
S-11
Highlighted
.)
2 min.
No Reset
OFF
OFF
OFF
Highlighted
.)
OFF
OFF
Thin
OFF
A warning message is given and the
copier inhibits the start of this copy
cycle.