Minolta EP5000 General, Mechanical/Electrical page 208

Interleaf EP5000/EP4000 DIS/REASSEMBLY, ADJUSTMENT
97.04.01
(12) Adjustment of the Image Leading Edge Erase Width
z Requirement
Dimension A
z Important
This adjustment should be made after the "adjustment of the leading edge registration" and
"adjustment of the leading edge registration for book second page".
With the "Adjust 1/2" menu on the screen, touch Next
3.
Touch the select key t or s to highlight "A12 Leading Edge Erase Adjust".
4.
1156D166CA
D The erase width, dimension A, on the copy of the GTC–test
chart should measure 1.0 to 6.5 mm.
D Setting range: 45 to 55
1134D135AA
1. Place the GTC-test chart face down on the Original Glass
and align its rear left corner with the reference marker on
the Original Width Scale. Then, lower the Original Cover.
2. Make three single copies on A3 or 11"
size mode and check the third copy for leading edge erase
width.
(If the erase width deviates from the specifications, per-
form the following steps to make the adjustment of image
1136D040AA
leading edge erase width.)
D-89
17" paper in full
to show the "Adjust 2/2" menu.
1156D159CA