Minolta EP5000 General, Mechanical/Electrical page 126

Interleaf EP5000/EP4000 DIS/REASSEMBLY, ADJUSTMENT
97.04.01
No. Part Name
1 Front Door
2 Control Panel
Original Width Scale
3
Original Glass
4
5 Rear Upper Cover (Small)
6 Rear Upper Cover
7 Right Cover
8 Right Door
(Manual Bypass Unit)
9 Counter Cover
10 2nd Drawer
11 1st Drawer
12 Original Cover
13 Upper Left Cover
14 Left Door (Exit/Duplex
Switching Unit)
15 Middle Left Cover
16 Rear Cover
Removal Procedure
Swing down No. 1. ! Remove two Front Door hinge shafts.
Remove one belt mounting screw inside the Front Door.
Raise No. 12. ! Swing down No. 1. ! Open No. 8. ! Re-
move No. 7. ! Swing down No. 14. ! Remove No. 13. !
Remove two control panel mounting screws. ! Remove two
magnet attraction plate screws. ! Unplug one connector
from MSC Board. ! Remove one connector.
Raise No. 12. ! Remove two scale mounting screws.
Note:When the Original Width Scale has been removed, use
care not to lose two springs.
Raise No. 12. ! Open No. 14. ! Remove No. 13. ! Re-
move the screw cover. ! Remove one Rear Upper Cover
(Small) mounting screw.
Raise No. 12. ! Open No. 14. ! Remove No. 13. ! Re-
move No. 5. ! Open No. 8 ! Remove No. 7. ! Remove
one Rear Upper Cover mounting screw.
Open No. 8. ! Open the Multi Bypass Table. ! Remove
four Right Cover mounting screws.
Open No. 8. ! Remove two cover mounting screws. !
Remove the harness from one wiring saddle. ! Unplug
three connectors. ! Remove two Right Door mounting
screws.
Snap off the Counter Cover. (It is secured by catches at two
places.)
<Except 120V Areas>
See p. D-17
<120V Areas>
See p. D-18
Remove No. 12 by pulling up.
Swing down No. 14. ! Remove six Upper Left Cover
mounting screws.
See p. D-61
Remove No. 13. ! Remove two Middle Left Cover mounting
screws.
Remove six Rear Cover mounting screws.
D-7