Minolta EP5000 General, Mechanical/Electrical page 145

Interleaf EP5000/EP4000 DIS/REASSEMBLY, ADJUSTMENT
97.04.01
1156D037AA
0 to
–1mm
A
1136D115AA
1156D038AA
1139D112AA
12. Remove two set screws and the electromagnetic spring
clutch.
NOTES
D When reinstalling the electromagnetic spring clutch, ori-
ent the Paper Take-Up Roll shaft and the clutch as
shown on the left.
D The end of the clutch must be flush with or slightly re-
cessed (up to 1 mm) from the end face of the Paper Take-
Up Roll shaft. (The roll shaft should never protrude.)
D There must be a gap of 1 mm or more at A when the Pa-
1136D114AA
per Take-Up Roll shaft is pushed in the direction of the
arrow.
13. Snap off two C-clips and remove the Paper Take-Up Roll
Assy.
14. Snap off three C-clips and remove the Feed Roll.
D-26