Displaying/Editing Machine Data - Siemens SINUMERIK 840D sl Commissioning Manual

Machine and setting data

5.2 Displaying/editing machine data

5.2 Displaying/editing machine data
In the "Startup" operating area, you can display lists for machine data. You can also modify
machine data here.
● General machine data ($MN )
● Channel-specific machine data ($MC )
● Axis-specific machine data ($MA )
● Drive-specific machine data ($M_)
● Machine data control unit: Drive parameters
● Machine data feed-in: Drive parameters
● I/O component parameters: Drive parameters
● Communication parameters (CULINK, DMC): Drive parameters
Note
The display of the machine data/drive parameters depends on the configuration of your
controller.
Access to the machine data operating area can be controlled by keylock switch or
password.
Read access to machine data is set to protection level 4: i.e. keyswitch position 3 can be
used to change the machine data to protection level 1 (machine manufacturer password).
Information about machine data
The following information is displayed from left to right:
● Machine data number, with field index if applicable
● Machine data name
● Value of the machine data
● Unit of the machine data
● Effective
Note
If the machine data does not use units, the corresponding column is empty. If the data is
not available, the "#" symbol is displayed instead of the value. If the value ends in an "H",
it is a hexadecimal value.
38
DANGER
Changes in the machine data have a considerable influence on the machine. Incorrect
configuration of the parameters can endanger human life and cause damage to the
machine.
Commissioning Manual, 07/2007, 6FC5397-1DP10-2BA0
HMI sl (IM9)