Customizing The "Machine" Operating Area; Setting The Size Of The Actual Value Display; Configuring The Display Of The G-Code Groups - Siemens SINUMERIK 840D sl Commissioning Manual

Customizing the "Machine" operating area

6.1

Setting the size of the actual value display

In the "Machine" operating area, the actual value window is displayed, showing the axes in
two different font sizes. You can define how many axes should be displayed in a larger font.
Proceed as follows
Use the ACT_VALUE_FONT_ZOOM_MODE display machine data item to set the number of
axes that are to be displayed in a larger font.
Depending on the number of axes that are displayed in a larger font, the number of axes that
are displayed in the overall view is reduced. If, for example, four axes are displayed in a
larger font, only a total of five axes are displayed in the window.
6.2

Configuring the display of the G-code groups

The "G-functions" pane is visible in the "Machine" operating area.
Up to a maximum of 16 G-code groups are displayed in this pane. Configure the
"sl_window_g_code.ini" file accordingly to determine which G-code groups should be
displayed, and where.
Configuring G-code groups
Enter the G-code group and position as follows:
"SelectedGGroupN=M"
● N: Position where G-code group M will be displayed.
● M: The number of the G-code group to be displayed at position N
HMI sl (IM9)
Commissioning Manual, 07/2007, 6FC5397-1DP10-2BA0
If you want to leave a position empty, omit the number (M), e.g. "SelectedGGroup1 =
"
6
51