Send Information Subscreen; Figure 22. Receive Information Subscreen - ST STM32F100 Series Application Note

Hide thumbs Also See for STM32F100 Series:

Table of Contents

Value line evaluation board CEC demonstration

Note:

The STM32F100xx Value line CEC responds only to the following commands (to other

commands, it sends a feature abort):

●

Standby

●

Get CEC version

●

Give physical address

●

Give OSD name

4.6.2

Send information subscreen

This subscreen is used to navigate among the connected device addresses by using the

RIGHT and LEFT buttons. After selecting the follower address, you have to select the

command to be sent to the selected follower address with the LEFT, RIGHT and SEL

buttons. Once you have selected a command, the CEC device sends this command to the

selected follower address, and displays the transmission status.

You can then select a new follower address and a new command.

32/36

Doc ID 16896 Rev 2

AN3127

Table of Contents

Do you have a question about the STM32F100 Series and is the answer not in the manual?