System requirements
Information concerning the device
3
System requirements
3.1
Information concerning the device
separate basic instructions of the device manual
This manual describes the AS-i controller e device family from ifm electronic gmbh with the option
Ethernet TCP/IP interface.
3.2
Information concerning the software
separate basic instructions of the device manual
3.3
Required accessories
Basic functions separate basic instructions of the device manual
For configuration and programming you also need:
the software "CoDeSys for Automation Alliance™" version 2.3 or higher
CD
article no. AC0340
in case of direct connection of the controller e to a PC with Ethernet interface (LAN):
a cross-over CAT5 Ethernet patch cable with an RJ45 connector on both sides:
2 m
article no. EC2080
5 m
article no. E30112
in case of connection of the controller e to a PC with Ethernet interface (LAN) via a hub or switch:
a common CAT5 Ethernet patch cable with an RJ45 connector on both sides
in case of direct connection of the controller e to a PC with serial interface:
programming cable article no. E70320
3-1