Substitute Value Behaviour; Setup As Per Step 7; 24�1 Description Of The Setup Of The Device On A Simatic® S7 Controller; System Requirements - IFM Electronic Ecomat 300 AL1010 Device Manual

Io-link profibus master

Table of Contents

IO-Link master

23 Substitute value behaviour

If Profibus communication fails or if no valid process data is received from the

Profibus master, all device outputs are set to the parameterized substitute values�

Please refer to the chapters → Status/control module → Startup parameters and

Flexible module configuration → Startup parameters sections for the precise

parameterisation of substitute values�

24.1 Description of the setup of the device on a SIMATIC® S7 controller.

This document describes specific features associated with the setup of AL1010 on

an S7 controller�

This document is intended for S7 specialists� It does not cover a complete project,

just specific features associated with the use of the device�

It is assumed the user has knowledge of and experience in the operation of

PCs and Windows operating systems, and knowledge of the Siemens SIMATIC

software and Ethernet basics�

25.1 Software

You are working with the software STEP 7 version 5�5, service pack 3 (version

K5�5�3�0)�

25.2 Hardware

Hardware requirements for the Siemens SIMATIC software:

Please refer to the S7 documentation for the hardware requirements�

To integrate the device into the network, proceed as described in the

manufacturer's documentation for your controller� This section only explains

fundamental steps that are relevant for the connection with the device�

26.1 Creating/opening a project

► In the Siemens SIMATIC Manager, create a new project or open an existing

project�

Table of Contents