System Requirements - IFM Electronic Ecomat 300 Supplementary Manual

System requirements

Information concerning the device
3 System requirements
3.1 Information concerning the device
→ separate basic instructions of the device manual
3.2 Information concerning the software
→ separate basic instructions of the device manual
3.3 Required accessories
Basic functions → separate basic instructions of the device manual
For configuration and programming you also need:
•
the software "CoDeSys for Automation Alliance™" version 2.3 or higher
(→ CD)
•
In case of direct connection of the controller e to a PC with Ethernet interface
(LAN):
a cross-over CAT5 Ethernet patch cable with RJ45 plug on both sides:
2 m
5 m
•
In case of connection of the controller e to a PC with Ethernet interface (LAN)
via a hub or switch:
a common CAT5 Ethernet patch cable with RJ45 plug on both sides
•
In case of direct connection of the controller e to a PC with serial interface:
programming cable
article no. EC2080
article no. E30112
article no. E70320
3-1