Warning: Power Supply Safety; Caution: Wireless Safety - ABB E-Hub 2.0 User Manual

5 - Warning: Power Supply Safety

6 - Caution: Wireless Safety

7 | © 2019 ABB | DOC. N° 1SDH002109A1001 - ECN000125349 - Rev. A
WARNING!
ELECTRIC SHOCK HAZARD
Failure to supply power correctly or to follow all operating instructions correctly, may
create an electric shock hazard, which could result in personal injury or loss of life, and /
or damage the equipment or other property.
To avoid injuries and safely supply power to the product, complete the following steps:
1. Observe all the instructions for safety, installation, and operation
2. Make sure your hands are dry
3. Make sure that all the cables used:
Are in good condition before using them
•
Meet the product requirements and comply with the relevant standards and
•
regulations
4. Position cables with care. Do not position cables in places where they may be trampled
or compressed by objects placed on them
5. Make sure that the power-points and plugs are in good condition before using them
6. Do not overload the power-points and plugs
7. Make sure that the product maintains a proper grounding connection
8. Use a power supply that meets the product requirements and complies with the
relevant standards and regulations.
9. Connect power after the installation of the system has been completed
10. Never connect or disconnect the cables with the system or the external apparatus
switched ON.
The antennas used in the product have to be installed with care, to avoid any interference
with other electronic devices and to guarantee a minimum distance from the body (20 cm).
In case of this requirement cannot be satisfied, the system integrator has to assess the
final product against the SAR regulation.
ABB | E-Hub 2.0
Introduction | Caution: Wireless Safety