How To Supply Power To The Product; Power Supply Specifications; Power In Connector And Mating Connector Specifications - ABB E-Hub 2.0 User Manual

HOW TO SUPPLY POWER TO THE PRODUCT

1 - Power Supply Specifications

Power IN Connector
and Mating Connector
Specifications
41 | © 2019 ABB | DOC. N° 1SDH002109A1001 - ECN000125349 - Rev. A
This product is not provided with any ON/OFF switch.
The Power IN connector is the disconnecting means from the power supply network.
Power supply Nominal: 12 or 24 VDC; Range: 9 to 30 VDC with transient protection
Power consumption 4 W typical; 15 W maximum
Peak demand < 15 W
The power input is protected against: surge, noise, reverse polarity, over-voltage.
NOTICE
The Power IN connector is NOT protected against short circuit.
Always include an external fuse to protect the product!
The E-Hub 2.0 provides the Power IN connector on the rear side.
Connector Layout:
Connector Pinout:
Pin # Signal Type Description
1 Power IN + P
2 Power IN - P
3 NC NC
Connector Specifications:
• Base strip, Header
• Gender: Male
• Type: 3-pin, 3.5 mm pitch
Mating Connector Specifications:
• Pluggable screw terminal block
• Gender: Female
• Type: 3-pin, 3.5 mm pitch
• Example:
• Manufacturer: Phoenix Contact
• Part Number: MC 1,5/ 3-STF-3,5 - 1847068
• (or equivalent)
Positive power supply input
Negative power supply input
Not Connected
HOW TO SUPPLY POWER TO THE PRODUCT | Power Supply Specifications
ABB | E-Hub 2.0