HOW TO INSTALL THE PRODUCT
1 - How to Install the Product Using the Mounting Bracket
36 | © 2019 ABB | DOC. N° 1SDH002109A1001 - ECN000125349 - Rev. A
The product is intended for professional use and must be installed by qualified personnel
only.
The product must be installed in a secured location, accessible to authorized personnel
only (for example in a cabinet / technical compartment).
By default, the E-Hub 2.0 comes with a DIN rail mounting clip fastened on the bottom side.
You can use this to install the E-Hub 2.0.
Optionally, you can replace the DIN Rail Mounting Clip with the Mounting bracket (optionally
available).
See also:
•
"How to Install the Product Using the Mounting Bracket" below
•
"How to Replace the Mounting Bracket with the DIN Rail Mounting Clip or Vice Versa" on
page 37
•
"How to Install/Remove the Product on/from a DIN Rail" on page 40
To install the product in place, complete the following steps:
1. See "Mechanical Specifications" on page 34
2. Use the 4 slots available on the Mounting Bracket
3. Add all the necessary mounting hardware to safely fasten the E-Hub 2.0 in place according to
your installation requirements (for example use 4x M5 screws, with a minimum length of 15 mm).
Material, type, and length of the screws, and the maximum torque applicable, depend on
your installation requirements.
The Mounting Bracket is made of 2 mm aluminum alloy 6061 T6.
Fig. 14
HOW TO INSTALL THE PRODUCT | How to Install the Product Using the Mounting Bracket
ABB | E-Hub 2.0