Pnp / Pci Configuration Setup - Procomp B687 Manual

B687

PNP / PCI Configuration Setup

PNP OS Installed
Resources Contorlled By
Reset Configuration Data
IRQ-3 assigned to : PCI/ISA PnP
IRQ-4 assigned to : PCI/ISA PnP
IRQ-5 assigned to : PCI/ISA PnP
IRQ-7 assigned to : PCI/ISA PnP
IRQ-9 assigned to : PCI/ISA PnP
IRQ-10 assigned to
IRQ-11 assigned to
IRQ-12 assigned to
IRQ-14 assigned to
IRQ-15 assigned to
DMA-0 assigned to
DMA-1 assigned to
DMA-3 assigned to
DMA-5 assigned to
DMA-6 assigned to
DMA-7 assigned to
PNP OS Installed
If you have installed a Plug and Play operating system such as Windows 95 or 98,
you can change this item to Yes. When the item is set to Yes you can use the Device
Manager utility in the operating system to make changes to the configuration of
expansion cards.
Resources Controlled By
You should leave this item at the default Auto. If you find that you cannot get
a particular expansion card to work properly, you might be able to solve the
problem by changing this item to Manual, and defining the characteristics of
the card in the new items which appear.
If you change this item to Manual, the display will list a series of items that
allow you to define the assignments of the system interrupt lines (IRQS) and
Direct Memory Access (DMA) channels. As a default, these items are set to
PCI/ISA PnP. If you install an ISA Bus card that does not support PNP, and it
ROM PCI/ISA BIOS(2A69KPND)
PNP/PCI CONFIGURATION
AWARD SOFTWARE, INC.
: No
: Manual
: Disabled
: PCI/ISA PnP
: PCI/ISA PnP
: PCI/ISA PnP
: PCI/ISA PnP
: PCI/ISA PnP
: PCI/ISA PnP
: PCI/ISA PnP
: PCI/ISA PnP
: PCI/ISA PnP
: PCI/ISA PnP
: PCI/ISA PnP
39
PCI IDE IRQ Map To
Primary IDE INT#
Secondary IDE INT#
Used MEM base addr
Assign IRQ For VGA
Assign IRQ For USB
↑↓→←: Select Item
ESC: Quit
F1 : Help PU / PD / + / - : Modify
F5 : Old Values (Shift)F2 : Color
F6 : Load BIOS Defaults
F7 : Load Setup Defaults
Default: No
Default: Manual
: PCI-AUTO
: A
: B
: N/A
: Enabled
: Enabled