Procomp B687 Manual page 35

B687
EDO CASX# MA Wait State
EDO RASX# Wait State
SDRAM RAS-to-CAS Delay
SDRAM RAS Precharge Time
SDRAM CAS latency Time
SDRAM Precharge Control
Theses items are setting by Auto Configuration.
Auto Configuration : By default, this parameter is set to Enabled. This
automatically enters and locks the optimum settings for the chipset. Disable
the parameter to unlock the settings without changing them.
System BIOS Cacheable
System BIOS segment is cacheable if this item been enable.
Video BIOS Cacheable
Video BIOS segment is cacheable if this item been enable.
Video RAM Cacheable
Video RAM segment is cacheable if this item been enable.
8 Bit I/O Recovery Time
The recovery time is the length of time, measured in CPU clocks, which the
system will be delay after the completion of an I/O request. This delay takes
place because the CPU is operating so much faster than the input/output bus
that the CPU must be delayed to allow for the completion of the I/O. This
item allows you to determine the recovery time allowed for 8- bit 1/0.
Choices are from NA, 1 to 8 CPU clocks,
16 Bit I/O Recovery Time
This item allows you to determine the recovery time allowed for 16-bit 1/0.
Choices are from NA, I to 4 CPU clocks.
Memory Hole At 15M-16M
In order to improve performance, certain space in memory can be reserved
for ISA cards. This memory must be mapped into the memory below 16MB.
Default: 1
Default: 1
Default: 3
Default: 3
Default: 3
Default: Disabled
Default: Enabled
Default: Enabled
Default: Enabled
Default: 1
Default: 1
Default: Disabled
33