Procomp B687 Manual page 38

B687
If you would like to use Software Power-off Control function, you cannot
choose" Disabled "here, and should select "Yes" in PM Control by APM.
PM Control by APM
Windows 95 and 98 have built-in power management capabilities called
APM (advanced power management). When you enable this item, you allow
the APM routines in Windows to operate on your system.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+ Blank
Blank
Screen
DPMS
Video Off After
When enabled, this feature allows the VGA adapter to operate in a power
saving mode.
N/A
Suspend
Standby
Doze
MODEM Use IRQ
This item determines the IRQ in which the MODEM can be used.
The choice: 3,4,5,7,9, 10,11,N/A.
Doze Mode
If you have selected User Define for the Power Management item, you can
set this item to a selection of timeouts from 20 seconds to 40 minutes.
hr. except for HDD Power Down which ranges from I to
15min. and disable
This selection will cause the system to turn off the
vertical and horizontal sync. ports and write
blanks to the video buffer
This option only writes blanks to the
video buffer
Initial display power management signaling
Monitor will remain on during power saving
modes.
Monitor blanked when the systems enters the
Suspend mode.
Monitor blanked when the system enters Standby
mode.
Monitor blanked when the system enters any
power saving mode.
Default: Yes
Default: V/H SYNC+Blank
Default: Standby
Default: 3
Default: Disable
36