Installing The Temperature Sensor Cable; Installing The External Battery Backup - Ericsson RBS 3107 Installation Instruction

Hide thumbs Also See for RBS 3107:

Table of Contents

Installation Instruction

3.4.1

Installing the Temperature Sensor Cable

This section describes how to connect the temperature sensor cables to the

DC filter.

3.4.2

This section describes how to connect the power cables from the external

battery backup to the DC filter.

All manuals and user guides at all-guides.com

Ensure that the temperature sensor

cable on the upper side of the DC

filter is connected as shown in the

figure.

Route the cable on the left-hand side

of the cabinet, well separated from

other cables, and connect it to the

BFU.

Loosen the screws and lift up the DC filter.

Connect the temperature sensor

cable from the external batteries to

the D-sub connector of the DC filter.

Note: The figure shows the bottom

of the DC filter.

BFU

1/1531-COH 109 2073 Uen H 2006-11-06

BFU

P015179B

Table of Contents